On each product page under the product description, there is a size chart for each model.
Once you select your favourite model, measure the feet as described in the instructions below. The feet length is recommended to be within the range defined for the corresponding size on the product page. The “Max circumference (toes)” should be no more than the value specified in the size chart for the corresponding model and size.
Max circumference for regular fit is displayed on the size chart. For models where you can specify the fit (wide, regular, narrow), please have in mind that NARROW fit is “-5 mm” and WIDE fit is “+5 mm” compared to the regular fit. Soles are the same for all fits. However, more/less tow room is provided based on the leather cut.
Take exact measurements with a slightly tightened sewing tape measure. Give us precise measures – do not round up or down, nor give us approximations and ranges because even a difference of 5 mm could be crucial to the proper fit of the shoe on the foot. If the feet of the child are more specific (wide/narrow, high/low, etc.), give us detailed information so we can advise you better.
Take a soft tape measure or a thread.
Kids foot length (1): Put your kid’s feet against the wall. The feet must be in a line, the heels should touch the wall. Mark off the tips of the two longest toes with a book.
The foot length is equal to the distance between the point where the tip of the longest toe touches the book to the point where the tip of the heel touches the wall – a diagonal and not a perpendicular.
Toddlers’ foot length: It will be easiest to take this measure while the baby is sleeping. Use a lid from a cardboard box and place the heel against one of the folds. Mark off the tip of the longest toe on the lid, then measure the distance between this point and the point where the tip of the heel touches the fold and add about 5-7 mm, thus you will have the actual foot length.
Circumference toes (2): This measure must be taken by overlapping soft measuring tape or a piece of thread around the widest part of the toes (the “ball” – just behind the base of the toes). This measure must be lower than the maximum circumference written in each product size table for the size you choose.
Circumference arch-midfoot (3): This measure is usually 5-10 mm longer than the measurement of circumference toes. In case it is significantly more than 10 mm, contact us.
Circumference heel-ankle (4): This measure is important in all models with strap closure in front of the ankle. We can customize the length of the strap in case you generally know that you face problems with longer or shorter straps in most shoes.
1) If you wonder between two sizes, choose the larger one – it will fit well soon :).
2) Measure both feet. If one is longer, use the measurement of the longer one.
3) If you do not have a soft tape, use a thread and then measure its length with a ruler.
4) If your baby’s feet are specific in some other areas (ankle, arch, etc.), send us the additional measurements (as in shown in 3 and 4 on the foot diagram) and information in order to determine whether our model will fit well and if we need to make a customization. Please note that there is an extra charge to all customisations.